DIY Marble Phone Charger

Wednesday, January 13, 2016

materials

contact paper
phone charger
nail polish
a container (that can be ruined by nail polish)
tape measure ruler
scissors
directions

step 1. measure the circumference and the height of your charger. [my circumference was four and a half inches and my height was one and a half inches.]

step 2. on the back of the contact paper with the dimensions from step one, draw a box. [my box was four and a half by one and a half.] optional: if you want to cover the side where the usb cord plugs in, then trace that side somewhere along the width of your box. in the end I didn't want mine to cover that side, but you might like it.

step 3. fill the container [that you don't mind ruining] with water and drop a couple of drops of nail polish into the water. some may sink to the bottom, so drop until it floats. then swirl the nail polish around in the water [I used a toothpick].

step 4. place the contact paper face down into the water, pull it out, and let it dry.

step 5. cut out the template, peel off the back, and stick it to your charger.

No comments:

Post a Comment

Exodus Treasures Copyright © 2017